Installing the roofing felt.
How to install roof flashing against a stucco wall.
If you dont have the step flashing on your shingled ro.
If the stucco has not been installed then the flashing should be underneath the stucco.
When the plywood deck is in place slide the 6x6 flashing down to the deck and nail to the deck at the outside edge of the flashing.
Check out our recommended tools right here.
For step flashing with a stucco wall you will be working in part on the roof.
Above the roof sheathing.
After you have gathered all your materials you will lay roofing felt over the area that will have flashing.
It is important to overlap any old roofing felt by at least one foot.
I cut the tape so that it laps onto the housewrap above and 3 in.
Check out our recommended tools right here.
Slide a 6x6 galvanized flashing up behind the stucco and paper.
Flash onto the surface of the existing stucco.
I use a wide piece of flexible flashing tape to protect the area between the subfascia and the wall.
The new roof is sealed to the flashing you just installed.
However the principles are the s.
Use your hammer and nails to secure the felt into place.
If you do all this carefully and neatly the existing stucco stays and looks fine.
Once the flexible flashing is set i apply a piece of housewrap along the wall where the fascia meets it.
When you have finished installing the flashing use either caulk or additional stucco to seal around the edges and prevent water infiltration to the roof.
Wrap the top of the wall with the wrb and install a new cap flashing.
Stucco presents its own logistics problem.
If you ll be installing step flashing in which one piece of flashing is placed over the first in a staggered way apply additional cement and the next piece of flashing.
Attach it to the roof in the same way.
Apply the roofing felt and nail the first piece of step flashing to the lowest.
Flexible flashing tape seals the eave to the wall.
Then install new stucco over the existing including a wrb.
