How To Install Vinyl Drip Edge For Vinyl Gutters

Slide one end into the j channel and nail the far side of the soffit to the wood fascia board using one nail to keep the soffit in place until you install the vinyl fascia.

How to install vinyl drip edge for vinyl gutters.

Just be sure they re positioned high up under the shingles. Install by nailing under shingles. Cut your soffit pieces. Place the drip edge down aligning it so water will drip into the gutters.

Make sure the corner is tight and that the bottom edge is tight to the fascia before nailing off the drip edge. Since soffit runs perpendicular to the wall you will be cutting many short pieces depending on the width of your overhang. Made from high quality vinyl construction. The roof leg should extend a minimum of 2 back onto the roof sheathing.

Then secure gutter hangers along your house and fit the gutter sections into them. Next attach drainpipes to carry water from the downspout outlets to the ground and away from your house. Place a nail at one end then the other. While the vertical leg should be placed 1 4 1 2 away from the fascia.

If necessary secure the ends of the drip edge with short roofing nails. The end with the flange or flare should point down and away from the roof. Most overhangs are 6 or 1. Drip edge is used to direct rainwater off of the roof and into your gutter system.

To install a drip edge on a newly constructed roof or on a re roofing job attach the drip edge along the roof s eaves first. You may need to nail through the starter strip into the drip edge. Nailing edge with 1 in. To install vinyl gutters you ll need to start by installing downspout outlets on the edges of your house so water can drain properly from the gutters.

Apply a continuous bead of cement along the top of the drip edge then press down on the shingle. Slide the corner tight to the fascia. Be sure to tuck the drip edge under the starter strip and felt paper. Secure the drip edge with roofing cement.

Overhanging drip edge gives maximum protection from roof run off. Use roofing nails to secure the drip edge. Drip edge flashing can be used for new construction and reroofing projects.