Use join unjoin roof tool.
How to merge gable roof with hip roof revit.
Use it to extend the dormer roof to the main roof.
Click architecture tabbuild panelroof drop down roof by footprint.
I believe this tools are not design for this purpose.
Select build roof roof plane from the menu.
Repeat steps 2 and 3 to generate the gable roof.
Then use the join geometry tool to clean up the intersection of the 2 roofs.
Release the mouse button and then click inside the room to identify the location of the ridge and to create a.
Method 1 gable roof with offset ridge.
Enjoy the videos and music you love upload original content and share it all with friends family and the world on youtube.
Yes i m not sure how you want the final roof to look but i m going to assume you don t want to see the highlighte roof edge on the gable side.
Draw geometry similar to below and select all but 3 top edges as shown.
Revit roof slope can seem complicated at first glance but by learning a few critical features you can create any roof shape you desire.
The first method works only for gable or shed roofs but not hip roofs.
A hip roof is a type of roof where all sides slope downwards to the walls usually with a fairly gentle slope.
You need to create the bay window roof separately.
Then follow these 2 steps.
Creates a roof using the building footprint to define its boundaries.
To create a dormer model required walls and additional roof.
The second works for all roof types.
For creating complex roof it might be easier if you create separate roof then use join roof tool to join them later.
Display a floor plan view or a reflected ceiling plan view.
Starting on the left hand side of the plan click and drag a baseline down along the outside surface of the wall s framing layer.
If you choose not to move the roof to a different level revit notifies you later if the roof.
When object snaps are enabled the program will snap the roof planes baseline to that point automatically.
Note that you cannot add the second roof by editing the sketch of the first.
There are 2 ways to extend the roof parallel to a ridge.
If you try to add a roof on the lowest level a dialog prompts you to move it to a higher level.
Whether you want a double gable roof with 6 pyramid shaped dormers or a simple gambrel roof the basics remain the same.
If desired set the lines of the second roof to be slope defining except the roof line that will be coincident with the first roof or the wall.
This is the easiest way to do it.
This tool is located in the modify tab.
So you would use the opening tool pick the roof you want to cut and draw the shape you want removed from the roof.
After you sketch walls and a roof for your design sketch another roof that you want to join to the original roof.
