Slip the wide flat flange of the material all the way under the first course of roof shingles as illustrated.
How to properly install drip edge with existing gutters.
Secure the drip edge with roofing cement.
The best practice is to always install the drip edge so that it is inside the gutter.
A drip edge or a gutter apron keeps your roof secure by filtering out all the water from the attic into the gutter.
Drip edge roof flashing types.
A drip edge is intentionally installed in a tilted position so that it can direct the water away from the roof while protecting the foundation of the roof.
He said that the gutters ahould go over the flange of the drip edge i e the drip edge would be between the gutter and the soffit.
If you are installing a roof system drip edges and gutter aprons play the main role.
Drip edges have two key purposes.
Lift the shingles slide the drip edge underneath them and position it so that it extends over the gutters then replace the shingles and push down to seat the drip edge.
With without rain gutters.
The whole purpose is to direct the water into the gutters.
Turns out not all drip edge flashing perform the same.
To install drip edge properly start on the eaves.
Due to cohesion surface tension and other forces water droplets tend to stick to one another and to the surfaces they are on albeit slightly.
But everything i ve read here says that the gutter should be under the drip edge.
How to install a drip edge.
L shape drip edge is a simple 90 degree bend with a flare out at the bottom of the short leg.
If not installed properly this will impact the effectiveness of your whole gutter systems.
Tools supplies tin sn.
It should never be installed outside the gutter i e against the fascia board.
T shape drip edge is an l shaped flashing in which the long leg folds back on itself before heading down.
It allows the rainwater to drain out of the roofing system and into the gutter.
For proper water drainage the drip edge on the rakes should always overlap the drip edge on the eaves.
A drip edge is a non eroding stainless material that is placed on the edge of the roof.
A drip edge is designed to take advantage of those forces and along with gravity direct water into the gutter.
Make sure the outer edge extends over the gutter.
Begin at the corner of an eave where it meets the next eave or a gable rake.
Measure how far the top of the drip extends past the front face usually 3 4 or somewhere thereabouts and allow the first piece to extend that far past the corner of the eave.
We can also relate it to gutter systems.
Coat the flat part of the flashing that sits on the deck using a putty knife.
He says that this could let the water get back under the edge and onto the roof deck.
Apply roofing cement when installing drip edge on an existing roof.
If it doesn t pull the drip edge out slightly from under the shingles.
Installing drip edge on your roof.
