How To Put On A Metal Roof Yourself

Slide the edge up through the offset cleat so that it is fulling engaged and flush along the edge.

How to put on a metal roof yourself.

The ridge cap helps water to flow off of the roof. Be sure the larger edge is laid so that the small edge of the next panel will overlap it. In a standing seam roof long single panels run vertically all the way from the eave to the ridge. Apply a thin line of butyl tape sealant along the roof s ridge.

Use your neoprene washer head screws to secure the metal to the sheathing. Space the screws about 12 in 30 cm apart down the entire piece of metal. Install the roofing screws vertically along each rib in the panel. Apply butyl tape sealant in a thin line along the length of the foam closures.

Make sure that the panel is sitting back from the edge of the roof by half an inch. If you want to install steel over asphalt your best choice for installing metal roofing is to use a steel shingle system like the one shown instead of the more common and more expensive standing seam steel. Align the first metal roofing panel so that it overlaps the edging by 1 2 to 3 4 of an inch and is square to the roof line. Place the ridge cap over the roof.

Now that we have put the one inch clip on the metal panel and cut the ribs back flush we can install the panel by clipping it into the offset cleat.