Pull out the motor unplug the wire plug in the new motor and reverse everything.
How to replace awning motor.
Here we cut the remainder of the old awning fabric from the roller and pulled out the polly cord from the retaining track.
The steps to replace the rv awning are almost the opposite of the removal.
Replacing the motor on a solara power awning extend your awning about 2 feet.
Replacing the rv awning.
Client on a budget.
Lift the roller up so it comes loose from the arm.
Replace the awning on the rv with your helpers lift the arms of the awning against the rv walking the awning in slowly as someone feeds the fabric back into the channel.
Reinstall the gear for the manual handle.
We ll show you step by step how easy it is to do it yourself.
Unbolt the chain from the drive shaft of the awning motor.
Do this on both ends.
New motor and wind sensor.
This will give you room to work.
Use the manual override if the motor is completely.
Tie the awning arms off to the bracket where it attaches to the side of your rv.
Check the manufacturer s instructions for fabric recommendations.
Install a new motor and tighten the bolts.
Loosen the bolts holding it in place and lift it out of the housing.
Purchase a replacement awning fabric.
Use high quality heavyweight tight weave vinyl for the best results.
You will need pop rivets reinstall the end cap.
Don t pay a shop to to replace your powereed carefree of colorado rv patio awning fabric.
Once the awning is in place make sure the lower section of the legs are locked in so you don t have to worry about it falling.
Drill out the rivets holding the end of the cap on the end of the roller.
Attach the hardware one by one.
Unplugging the rv awning motor wire we carefully stepped down and placed the awning roller on the ground.
Refer to the owner s manual as the parts included can be slightly different from manufacture to manufacturer.
Start by measuring your awning from the inside of each cap.