How To Replace Electric Awning Motor

Be sure to apply tape before sliding the awning off the rv.

How to replace electric awning motor.

Unbolt the chain from the drive shaft of the awning motor. 4 6 out of 5 stars 34. You have to connect back the wiring connection at the awing wiring and coach wiring before you do this step otherwise you wont have the voltage. Get to the motor using a ladder and open it up.

Free shipping by amazon. Replace electric awning fabric. Loosen the bolts holding it in place and lift it out of the housing. Solera awning motor wires remove the 3 bolts that hold the motor in place using a 10mm wrench or socket.

Remove the connection and test the voltage at that point. Get it as soon as sat sep 19. Aecojoy 10 8 patio awning retractable sun shade awning cover outdoor patio canopy sunsetter deck awnings with manual crank handle beige. Loosen the roller end bracket securing bolts and remove the bracket from the torsion bar by sliding it to the left end of the bar.

After your awning is safely on the ground remove the end cap. Pull out the motor unplug the wire plug in the new motor and reverse everything. Install a new motor and tighten the bolts. You will need pop rivets reinstall the end cap.

Best seller in patio awnings. This will make sure they don t scratch the side of the rv. Remove the bad motor and replace it with the new one. The dual connector three bolt system was engineered with minimal components for fast user friendly installation saving you time and money from taking your rv or camper into the shop.

Drill out the rivets holding the end of the cap on the end of the roller. With the solera power awning replacement motor your awning will be operating as usual in no time. Unscrew the panel box and access the point where it makes the connection. You will possibility need two ladders.

You may have to rotate the motor slightly to get the gears to line up and then rotate it back in place to line up the bolt holes. Carefree r001326wht white rv travel r electric awning replacement motor. Cover the upper awning brackets with electrical tape or masking tape. This should be done in a retracted position.