Be sure that the hem of the fabric is facing down.
How to replace sunsetter awning fabric.
Repeat for the other side of the awning.
For awnings that have a sunsetter aluminum hood installed remove the hood end plate on the opposite side of the motor or gear assembly.
Hold the front bar and loosen the left front bar insert with a 5mm allen wrench and pull the insert out of the front bar.
Slide the fabric onto the roller bar and awning rail at the same time until approximately 6 is still extending out of the roller bar on the left side.
While keeping the fabric reasonably stretched on the roller bar turn the crank wand counter clockwise to slowly roll the fabric onto the roller bar.
Locate the replacement valances and trim the gray cord to a length of inch on each end.
Also make sure that the valance is in the channel you marked with a v.
Insert the new valances into the front bars until they stop at the other end.
Tuck the ends of the fabric into the channels that you marked and ensure that it is centered.
Open the awning and allow the fabric to completely unroll.
Get out your new awning fabric and position it over the front of the roller tube.
Insert the cut end of the cord into the fabric slot on the roller bar and the other end of the fabric into the awning rail.
Insert new awning fabric into channels you marked.