Hammer nails into the rolled roofing to secure it.
How to secure roofing material to drip strip.
Neg s new drip strip installs easily behind the drip edge to prevent water and ice from getting behind the gutter and harming the fascia board.
It will stop water from going between the facia board and back side of the.
Make sure when driving the nails you also flatten the flashing as flat as possible.
Both raw material and finished product is made in the usa.
Gently lift up the shingles on the edge of the roof and locate the nails holding the existing drip edge onto.
I recommend using 1 trim nail in the center and one on every overlap of the ends.
Let me know if you need anything else.
Make sure you use a strong hammer and 1 inch 2 5 cm roofing nails.
Just be sure they re positioned high up under the shingles.
You need drip strip.
All you need to do is slide the wider side of the drip strip between the roof edging and the fascia board leaving the 70 degree offset portion of the drip strip hanging out past the back of the gutter.
Apply a continuous bead of cement along the top of the drip edge then press down on the shingle.
It can be done.
Dip a 2 inch wide brush into the cement and lay a 2 inch line of cement from end to end of the.
Once free slide the drip edge out and discard.
Open a can of roofing cement.
If necessary secure the ends of the drip edge with short roofing nails.
Ensure that you hammer the nails properly into the roof don t leave the nails sticking up above the layer.
If there isn t enough room then you could go through the drip edge.
Aluminum or stainless trim nails are fine.
To install drip strip it is simple.
Use a flat pry bar and hammer to pry the nails out of the drip edge gently.
Keep rain in the gutter with drip strip.
Remove the drip edge and apply a thin strip of roofing cement at the top edge above the line you marked and slide the drip edge back under the shingles to the mark you made.
Use a roofing nail 1 to tack the drip edge down one every 10 when placing two pieces of drip edge together overlap one end over the other by 1 and secure using two roofing nails one in the back and one in the front.
Atlantic drain do you have water running behind the gutter.
If you have enough room i would suggest nailing trough the drip strip into the fascia below the drip edge.
This is an asphalt based glue that will adhere to almost anything.
You can also use.
