How To Secure The Posts On A Gazebo Or Awning

Insert the posts into the concrete while still wet.

How to secure the posts on a gazebo or awning.

Fill large planters with a layer of sand and a thick layer of concrete. Twist and push tent stakes into the ground. This will make the white bases and bricks one unit and it should stabilize the gazebo considerably. If you want to secure your gazebo in windy conditions but you don t want to commit to anchoring it with screws or buying weights you can try securing it in the other ways for example with straps.

Use masonry screws and a masonry drill bit to attach the white bases to the bricks. The legs of the gazebo have a little lip on them that is held to the bottom of the pot with the bricks. Twist a 5 8 inch 1 6 cm nut onto the eyebolt on either side of the cap to sandwich your eyebolt in place a washer on the inside end and then twist a bolt on that end to secure it. Attach 5 8 inch 1 6 cm eyebolts to the caps with nuts and bolts.

Do this at the corner. Use at least four positioned at the four corners of the canopy. Here are the steps involved. Use either bungee cords or thick strong rope to secure the canopy to the tent stakes.

Insert 1 eyebolt into each hole that you drilled. Place a level on one leg of the gazebo to make sure it is plumb. Step 3 using a drill with a 1 2 inch diameter masonry bit slide the bit tip through the ready drilled slot at the bottom of the leg so it rests against the concrete. Twist some rope around the leg of the canopy to help anchor it.

I filled each pot with potting soil then planted pansies in each pot. Although there are several methods of securing a gazebo using pegs clips and ropes is one of the common method used by many. You can place one strap on each leg and tie to the nearest building tree or anything firm enough to withstand the force. Throw one end of the rope over the horizontal bar that is the edge of the roof.

To attach them to the gazebo take a 1 2 inch drill bit to each of the legs to prevent the wood from splitting then place the rods about 10 inches inside the leg and drive the remainder into the ground.