Never lay the tarp out during a storm.
How to tarp a roof without nails.
The 2 by 4 should be about 2 feet longer than the tarp width.
Here are the steps on how to install a tarp on your roof without nails.
Nail the tarp to the fascia board over the edge of.
Starting at a corner drive a galvanized roofing nail into the strip and into the roof sheathing.
Pull the tarp tight and smooth out wrinkles.
Make sure to tighten the tarp as much as possible to the structure.
Once you re on the roof and ready to rock and roll spread out your tarp to the coverage you want.
Most tarps have grommets that will allow you to tie off the tarp to your roof.
Then fold the excess tarp under a few rotations for a tight clean fit.
Roll the tarp over the damaged area taking care that it extends at least 3 on all sides.
You need to know first which spot on the roof needs tarping up.
Extend the top edge of the tarp over the roof.
Place the plywood or sheet metal over the hole and use roofing nails and a hammer or decking screws and a cordless drill to secure the plywood to the roof.
Thomas boni july 8 2018 at 3 29 pm.
Lay the tarp out flat over the roof.
Continue along the length of the ridge line.
Time wind and rain will eventually pull those nails right through the tarp if you don t use wood and you ll have a flapping tarp on your roof doing nobody any good.
Installing a tarp on your roof is easier than you think.
Your 2 4 should be two feet longer than the width of your tarp.
Don t simply nail into the tarp.
Next install furring strips to the parallel bottom side of the tarp.
Wrap your tarp around the board then secure the board to the roof with a screw.
It s even easier if you do it without nails.
The board must be 2 feet longer than the tarp s width and it should sit against the roof to avoid the collection of rainwater snow or debris.
Place the 2 4 against the roof along the rake to prevent water collection.
Using nails attach the peak end of your tarp to a 2 4.
Find the source of the leak.
Lay the tarp across the roof so that at least 4 feet 1 2 m lies on the sloped part of your roof on each side known as the peak.
These nails should be placed 12 to 18 apart.
Installing tarp on a roof without nails.
If your tarp is too.
Screw the 2 by 4 directly into the roof to secure it.
Let the rest of the tarp hang off the lower border of the roof that overhangs the wall known as the eave.
Create an anchor board by rolling the tarp s peak end with a 2 x 4 inch board and nailing the tarp to your board with your 3 inch nails.
