Working at heights is fraught with danger.
How to use roof anchor.
If a roof anchor point has not been certified in the previous 12 months it should not be used as it may not be in good working order.
From the edge of the roof.
An anchor point should be able to hold a force of 10 kn for as long as 3 minutes.
Using a fixed anchor point.
Mount the roof anchor to the peak no closer than 6 ft.
The rescue plan must have been tested to ensure that it is effective.
Anchor points are usually installed on the roof and are used to connect lanyards lifelines and other forms of tie off which prevent a worker from falling.
Of course this is quite difficult to measure.
What could render your roof anchor point unsafe for use.
Rust structural stress or vibration compromised building integrity and damaged height safety equipment could lead to your roof anchor points not meeting.
For that reason three of the most common methods to create an anchor point for work on a sloping roof are outlined below.
Why you need roof anchor points when working at heights.
If you run into a bunnings on a saturday afternoon and ask for a roof anchor fair chance that the staff will recommend the ankame roof anchor.
Falls from heights kill approximately 26 workers and injure another 7 700 each year in australia.
It is the responsibility of the supervisor to ensure that when using an anchor points system as a control measure there is an effective rescue plan in place.
If you or your employees are required to work at heights having the right roof anchor points is essential to prevent fall fatalities.
Relocate the anchor or add more anchors if necessary.
The applicable standard prescribes.
Ankame temporary roof anchor.
To the side of the roof anchor.
When using a roof anchor points system it is a legal requirement to establish emergency and rescue procedures.
Both permanent and temporary roof anchor points are available.
Don t work more than 4 ft.
Roof anchors can be as simple as a d ring connection or as complex as a complete lifeline system.