How To Use Roofing Nails

The first nail should be positioned in the barrel.

How to use roofing nails.

In most cases 4 nails are adequate. Cut drip edge flashing at an angle at the corner press it lightly against the eave end not too hard or you will misshape it and drive a nail near the end. That is why it is important to use roofing nails when doing a roofing job. Load the canister to load a roofing nailer s canister open the feeder door and the magazine door.

Fasten shingles with corrosion resistant nails. Roofing nails are made of galvanized steel to protect them from the elements. Many roofers use pneumatic nail guns to nail down the shingles. When the nails are overdriven the heads of the nails punch right through the mat of the shingle.

Use a chalkline or align it by eye to make sure it is straight then drive roofing nails every foot or so to fasten it to the sheathing. Roofing nails are used in roof installation to fasten shingles to install roofing felt for waterproofing and to attach roof tiles and sheet metal. A countersunk nail will rip the shingle and a nail that is not completely nailed down will eventually work its way out. When installing roofing nails always make sure the nail is flush to the shingle.

Install the recommended number of nails per shingle. When the pressure is set too high the nails simply get driven into the shingles too far. There are different kinds of roofing nails made of different materials and in various sizes. Remove the retainer from the coil and insert the coil into the canister with the nails pointed down.

Apply drip edge to the eave. All roofing nails have wide flat heads and short shanks.